Plan installation of cathodic protection system

1. Workplace safety, environmental and sustainable energy practices for the site are identified, obtained and understood

Completed
Date:

Job requirements are obtained and interpreted from plans, specifications and instructions

Completed
Date:

Relevant job requirements and workplace procedures for work activities are discussed with relevant person/s, including third parties, to determine and confirm work schedule and respective responsibilities

Completed
Date:

Hazards are identified, workplace safety and environmental risks are assessed, and control measures are prioritised, implemented and monitored in accordance with workplace procedures

Completed
Date:

Scope of responsibility under the relevant job requirements, including all work permits and/or relevant notifications, is determined and confirmed to access the services and perform work in accordance with job requirements and workplace procedures

Completed
Date:

Equipment, tools and personal protective equipment (PPE) needed to carry out work activities are identified, obtained and checked for correct operation and safety in accordance with workplace procedures and manufacturer instructions

Completed
Date:

Technical specifications and drawings are prepared from the analysed cathodic protection survey data and approved in accordance with job requirements and workplace procedures

Completed
Date:

Materials, plans, diagrams, drawings and resources required for work are confirmed and obtained in accordance with workplace procedures

Completed
Date:

Install cathodic protection system

1. Workplace safety and environmental risk control measures, schedule of work and workplace procedures for carrying out work are followed

Completed
Date:

Appropriate materials, tools and equipment are selected and used safely in accordance with manufacturer instructions and workplace procedures

Completed
Date:

Work is completed within agreed timeframe and to industry standards in accordance with job requirements and workplace procedures

Completed
Date:

Hazardous activities are conducted safely in accordance with regulatory requirements and workplace procedures

Completed
Date:

Alarms, codes and hazard warnings are correctly recognised, and the correct response strategy is selected and applied in accordance with workplace procedures

Completed
Date:

Faults and operational conditions of the components are identified, repaired or replaced, and reported in accordance with organisational job requirements

Completed
Date:

Unplanned events are referred to the relevant person/s for directions in accordance with workplace procedures

Completed
Date:

Test and commission cathodic protection system and complete relevant documentation

1. Installed cathodic protection system and components are commissioned and tested for conformance and anomalies reported in accordance with regulatory requirements and workplace procedures

Completed
Date:

Workplace safety risk control measures for work completion are followed

Completed
Date:

Quality and safety checks of the work are conducted in accordance with job requirements, workplace procedures and community and industry standards

Completed
Date:

Worksite is cleaned, reinstated and made safe in accordance with workplace procedures

Completed
Date:

Tools, equipment and any surplus resources/materials are cleaned, checked and securely stored in accordance with workplace procedures

Completed
Date:

Relevant work permit/s are signed off and equipment is returned to service in accordance with job requirements and workplace procedures

Completed
Date:

Cathodic protection system is tested and adjusted, and additional survey data collected.

Completed
Date:

'As built/as-installed' drawings are checked, updated and returned to the relevant cathodic protection engineering person/s in accordance with workplace procedures

Completed
Date:

Relevant person/s is notified of work completion in accordance with workplace procedures

Completed
Date:

Work completion documentation is completed accurately and provided to relevant person/s in accordance with workplace procedures

Completed
Date: